Ender Teardown, Rebuild
Labwork – Teardown Part 1
A few steps to crack open the Ender housing, replace extruder wires, internal fan wires, jumpers etc.
Check out the timeline below, quick editorial: Case removal, wires, replace section by section… replace covers. Voila! Step 2, coming shortly, the more difficult portion of the build as we are swapping extruders Bowden to Direct Drive, and back plate swap. Back plates don’t match, we will proceed with a salvaged plate (existing), harvest the plate, add new hardware… shouldn’t be to difficult.
I’ll post another update on the tool set I’ve recently added, Klein driver set… handy multitool to go with the new-ish Tekprem Torx set. Check back shortly as there is more to come in round two!
Comments are closed.