Print Plate Surface Adhesion and Heating Issues. Filaments
Lab Work – Ender Issues Defined
A few more weeks of Ender issues…
I’ll be posting more Ender ‘lite’ issues, as the TPU trial continues so does the filament challenges. Although, the filament change was strictly lab work for the bait designs down the road… same for some locking mechanisms etc. where application of TPU will be more suitable; (excuse the tangent), core printing hasn’t stopped and the challenges continue with PLA. Anything from slicer issues – Creality Software to Ultimaker Cura, Sonic Pad issues, filament run temp, new surface temperature issues… we’ve got a lot to cover.
I’ll break these down into 2 or 3 new posts over the next week. We will cover surface adhesion again as well. Surface adhesion and surface temp seem to cause most of the issues on the Ender Max Neo. I will reserve the right, tinkering doesn’t always produce perfect prints even 60%, 80% of the time. I would argue, the more runs the better in order to increase that 60% likelihood of printing successes.
I shared this picture specifically to cover thickness, fragility and test prints. Get to printing!