New Halot Sky LCD

Creality Halot Sky Resin 8.9″ LCD Change Out

Halot Sky LCD Replacement

Lab Work – LCD Screen

I know, we started the last post with “Before you start your own 3D printing…”; this post does follow suit. It looks like a bad LCD screen, that needs to be replaced, as well as the film stretched over the resin vat or possibly just some resin damage, for that matter.

We replaced the monochrome LCD screen on the deck of the Halot Sky while we wait for a new FEP resin vat. Please note, if you’re planning to change resin liners (if you manage to find the correct ones for CL-89), it’s a good idea to buy several of them because they can be difficult to find when global stock is low.

Swapped LCD Screen

Swap details: Deconstruct by removing all screws, covers and metal panels. Be careful to disconnect the wires and ribbon cable for the touchscreen. Replace the screen ribbon in the quick connect being careful to reattach the ribbon and black wire for the touchscreen.

Two, clean up any resin residue, pour over, and spillage now. I believe this is  where we made a mistake. The spillage got under the screen, as shown in the featured image for the article. Have a bottle of alcohol on hand to make the cleanup process as easy and effortless as possible. It took about 15-20 minutes in total, as I mentioned, due to the large amount of spillage. Finally, remove the ribbon tape surround and a few screws to gain access to the LCD screen.

Ideally, you’ll want to take your time, being careful to not to rip the LCD tape, or misplace a screw. If you do lose any items, you can always find new pieces in the Spare Parts. If not, try the eBay shop. We will provide a link to our wares but it’s taking some time due to logistical issues. We also sell out items on eBay from time to time, so check them out – we currently have some King books available.

For those who only need the FEP release film, or for our future reference – FEP Release Film – (search eBay for FEP Release film). A side note: FEP film can be hard to find, so eBay might be your best source. If i were a betting man, which I’m not, eBay or Amazon might be the only two sites where you can find spare parts and film. Cheers!

Before we move off the Halot updates, I’d like to share other Halot usage, new Creality series, break-fixes, and finally the idea of adding a resin printer to the 3d printer arsenal.

As usual leave a comment below, let us know what you’re thinking?

Halot Liner Before Change Out Halot Liner Before Change Out Halot Liner Before Change Out Halot Liner Before Change Out

Leave a Reply